Menu
Original price was: $149.00.$135.00Current price is: $135.00.
| Discount Level | Quantity | Discount % |
|---|---|---|
| 10% Volume Discount | 2 - 3 | 10% |
| 15% Volume Discount | 4 - 5 | 15% |
| 20% Volume Discount | 6 + | 20% |
-
CFS-ASHALT PATCH INSTALLATION INSTRUCTIONS
Reaches the strength of concrete in 24 hours, NO other asphalt patch can compare!
CFS-Asphalt Patch Kit is a three component 100% solids epoxy mortar designed for patching asphalt. (BLACK ONLY)
Similar to our CFS-Epoxy Mortar kits, this material is designed to stick to tar and asphalt.
All contents are packaged within a 5 gallon bucket. Inside the bucket, Part A & Part B of epoxy and sand are included. 30 lbs total weight.
Pour the sand into another bucket, mix part A & part B in the bucket thoroughly.
After mixing the epoxy, pour 1/2 of the sand back into the bucket, mix thoroughly paying attention to the bottom and edges of the bucket, pour the other half of sand into the bucket and mix thoroughly. +/- 2-3 minute mix time.
After the material is mixed, place it in the repair areas, trowel or tamp with a trowel as needed for your finish.
+/- 25 minutes of working time once material is mixed.
This can be seal coated after cure.
Material sets in +- 8 hours / Full cure is 48 hours
Preparation- pressure wash, wire brush to remove all dirt from surface prior to installation.
1 Kit = .25 cubic feet (approx.) 30 pounds ( 432 cubic inches)
TECHNICAL DATA SHEET:
SAFETY DATA SHEET:
FREE SHIPPING
Only logged in customers who have purchased this product may leave a review.
Reviews
There are no reviews yet.